DUMP-- This command will write
all previously defined spectra out to a series of files, each file corresponds
to one spectrum. The file type will start at .001 and will be incremented
each time a spectrum is written out.
‘Dump file name?’ asks you for the
file name to use. (Do not give an extension) SMAUG will assign .001, .002
etc as extensions to the spectra file names.
DUMPL*OAD-- This will load
a series of spectrum data files back into the program. The files will have
the same setup as written by the DUMP command.
‘Load file name? ‘ asks you for
the file name to use. (No extension). This option will by default
attempt to load the spectrum into I*2 words. If you wish to have the program
load the spectrum into other than 1*2 words, type a / after the file name
and a value indicating how many bytes per word you wish the program to
use. The valid values are 1=Byte 2=I*2 words, and 4=I*4 words.
Note : the spectra read back in are not automatically connected to the data stream (see DUMPLOAD+).
DUMPLOAD+-- This will act as DUMPLOAD does but has the additional feature that it will do an automatic CONNECT command to each spectrum as they are loaded into the program.